Using The Infocenter To Adjust The Machine Settings - Toro Greensmaster eTriFlex 3360 Operator's Manual

Using the InfoCenter
to Adjust the Machine
Settings
You can use the InfoCenter to adjust the following
machine settings:
•
Tap-off delay; refer to
(page 24).
•
Reel speed while mowing; refer to
Mowing Reel Speed (page
•
Reel speed while backlapping the cutting units;
refer to Adjusting the Backlap Reel Speed (page
24).
•
Clip control; refer to
Feature (page 25).
•
Height of cut (HOC); refer to
of Cut (HOC) (page
•
Number of cutting-unit blades; refer to
the Number of Cutting-Unit Blades (page
•
Maximum mowing speed; refer to
Maximum Mowing Speed (page
•
Maximum transport speed; refer to
Maximum Transport Speed (page
•
Maximum reverse speed; refer to
Maximum Reverse Speed (page
•
Slow in turn; refer to
Function (page 25).
•
Disabling an equipped 3-Wheel-Drive Kit; refer
to Disabling an Equipped 3-Wheel-Drive Kit (page
26).
Note:
Each setting is passcode-protected. You may
need to enter a passcode to edit the settings.
Adjusting the Tap-Off Delay
Navigate to the T
APOFF
tap-off delay. The tap-off delay feature allows the
cutting units to turn off without raising. The delay
setting represents the maximum time for the lift/lower
joystick to remain in the rearward position to activate
this feature.
Refer to the following table for the delay time options
and their corresponding increment numbers:
Tap-Off Delay Options
Increment Number
1
2
3
4
5
Adjusting the Tap-Off Delay
Adjusting the
24).
Adjusting the Clip-Control
Adjusting the Height
25).
Adjusting
25).
Adjusting the
25).
Adjusting the
25).
Adjusting the
25).
Setting the Slow in Turn
T option to adjust the
IME
Delay Time (Seconds)
Off
0.050
0.100
0.150
0.200
Tap-Off Delay Options (cont'd.)
6
7
8
9
10
Note:
The factory default setting is 1, which disables
this feature.
Adjusting the Mowing Reel Speed
Navigate to the R
EEL
speed while mowing. This setting can be adjusted
when the clip control setting is O
the Clip-Control Feature (page
Refer to the following table for the reel speed options
and their corresponding increment numbers:
Mowing Reel Speed Options
Increment Number
1
2
3
4
5
6
7
8
9
Note:
The factory default setting is 2000 rpm
(increment number 9).
Adjusting the Backlap Reel Speed
Navigate to the B
ACKLAP
speed while performing a backlap operation.
Refer to the following table for the reel speed options
and their corresponding increment numbers:
Backlap Reel Speed Options
Increment Number
1
2
3
4
5
24
0.250
0.300
0.350
0.400
0.450
S option to adjust the reel
PEED
; refer to
FF
25).
Reel Speed (RPM)
800
950
1100
1250
1400
1550
1700
1850
2000
RPM option to adjust the reel
Reel Speed (RPM)
200
240
280
320
360
Setting