After Operation; After Operation Safety - Toro Greensmaster eTriFlex 3360 Operator's Manual

1. Alignment strip
2. Approximately 12.7 cm (5
inches)
Important:
Never stop the machine on a
green, especially while the cutting units are
engaged; damage to the turf may result.
Stopping the machine on a green may leave
marks or indentations from the wheels.
Cutting the Periphery and
Finishing the Job
1. Finish cutting the green by mowing the outer
periphery. Change the direction of cutting from
the previous mowing.
Refer to Understanding the
Radius-Dependent-Speed (RDS) System (page
25) to improve the after-cut appearance and
reduce triplex ring.
Note:
Always keep weather and turf conditions
in mind and be sure to change the direction of
mowing from the previous cutting.
2. When you finish mowing the outer periphery, tap
the lift/lower joystick rearward to stop the reels
(if the tap-off delay feature is engaged), then
drive off the green. When all the cutting units
are off the green, move the lift/lower joystick
rearward to raise the cutting units.
Note:
This step minimizes grass clumps left on
the green.
3. Replace the flag.
4. Empty the grass baskets of all clippings before
you transport the machine to the next green.
Figure 33
3. Cut grass on the left.
4. Keep a focal spot 2 to 3
m (6 to 10 ft) ahead of the
machine.
Note:
Heavy wet clippings cause strain on
the baskets, suspensions, and actuators. This
adds unnecessary weight to the machine, which
decreases energy efficiency.

After Operation

After Operation Safety

General Safety
•
Engage the parking brake, shut off the engine,
remove the key, and wait for all movement to stop
before you leave the operator's position. Allow
the machine to cool before adjusting, servicing,
g005116
cleaning, or storing it.
•
Clean grass and debris from the cutting units and
drives to help prevent fires. Clean up oil or fuel
spills.
•
Shut off the fuel while storing or hauling the
machine.
•
Disengage the drive to the attachment whenever
you are hauling or not using the machine.
•
Allow the machine to cool before storing the
machine in any enclosure.
•
Maintain and clean the seat belt(s) as necessary.
•
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
Towing Safety
•
Tow only with a machine that has a hitch designed
for towing. Do not attach towed equipment except
at the hitch point.
•
Follow the manufacturer's recommendation for
weight limits for towed equipment and towing
on slopes. On slopes, the weight of the towed
equipment may cause loss of traction and loss of
control.
•
Never allow children or others in or on towed
equipment.
•
Travel slowly and allow extra distance to stop
when towing.
31