Toro Greensmaster eTriFlex 3360 Operator's Manual page 18

Service
Menu Item
H
OURS
C
OUNTS
B
ACKLAP
C
ALIBRATION
Settings
Menu Item
U
NITS
L
ANGUAGE
B
ACKLIGHT
C
ONTRAST
P M
ROTECTED ENUS
P S
ROTECT ETTINGS
R D
ESET EFAULTS
T T
APOFF IME
R S
EEL PEED
B
ACKLAP RPM
C C
LIP ONTROL
B C
LADE OUNT
H C (HOC)
EIGHT OF UT
Description
Lists the total number of hours
that the key, engine, reels, and
backlap have been on, as well
as the next service due.
Lists the number of starts,
mows, tap-offs, backlaps,
and number of times that the
engine was cranked longer
than 30 seconds.
Engages/disengages the
cutting-unit backlap procedure
(when you engage this
procedure, you can disengage
the mode with this setting or
by moving the key to the O
position).
Allows you to calibrate the
steering system, traction
system, and lift actuators.
Refer to the Service Manual
for more information on
calibration.
Description
Controls the units used on the
InfoCenter. The menu choices
are English or metric.
Controls the language used
on the InfoCenter.
Controls the brightness of the
LCD display.
Controls the contrast of the
LCD display.
Allows you to access
protected menus by inputting
a passcode.
Controls the protected menus.
Resets the InfoCenter to
default settings.
Controls the tap-off delay.
Controls the reel speed.
Controls the backlap rpm
speed.
Turns the automatic
clip-control feature O /O
N FF
Set the number of blades in
each reel. This setting is only
necessary if C C
LIP ONTROL
set to O .
N
Sets the desired height of cut.
This setting is only necessary
if C C is set to O
LIP ONTROL N
Settings (cont'd.)
M M
AX OW
M T
AX RANSPORT
M R
AX EVERSE
S & T
LOW URN
3WD K
IT
FF
About
Menu Item
M
ODEL
SN
S/W Rev
I C
NFO ENTER
CU1
CU2
CU3
G
ENERATOR
LL1
LL2
LL3
T 1
RACTION
.
T 2
RACTION
is
S
TEERING
.
18
Sets the maximum machine
speed while mowing.
Sets the maximum machine
speed while transporting.
Sets the maximum machine
speed while moving the
machine in reverse.
Enables or disables the slow
in turn function.
Enables or disables the
3-Wheel Drive Kit.
Description
Lists the model number of the
machine.
Lists the serial number of the
machine.
Lists the software revision of
the master controller.
Lists the software revision of
the InfoCenter.
Lists the software revision of
the center cutting unit motor .
Lists the software revision of
the front, left cutting unit motor.
List the software revision of
the front, right cutting unit
motor.
Lists the serial number of the
generator.
Lists the software part number
and the revision version for
the center cutting unit.
Lists the software part number
and the revision version for
the front left cutting unit.
Lists the software part number
and the revision version for
the front right cutting unit.
Lists the software part number
and the revision version for
the front right traction motor.
Lists the software part number
and the revision version for
the front left traction motor.
Lists the software part number
and the revision version for
the rear steering motor.