Caring For The Battery Pack; Understanding The Battery Charger - Toro Greensmaster e1021 Operator's Manual

Caring for the Battery Pack

The lithium-ion battery holds a sufficient charge to
perform intended work during its life span. As time
goes by, the total amount of work the battery is able
to complete on a single charge gradually diminishes.
The following table lists the approximate expected
work that the machine should be capable of over the
first 4 years of use:
Year
Area Cut Per Full Charge
1
2
3
4
Note:
Your results may vary depending on the
distance you need to transport the machine, the
contact setting of the bedknife, and other factors as
discussed in this section.
To achieve maximum life and use from your battery,
apply the following care guidelines:
•
Do not open the battery pack. There are no
user-serviceable parts inside.
•
Store/park the machine in a clean, dry garage or
storage area, away from direct sunlight and
heat sources. Do not store it in a location where
the temperature drops below -30°C (-22°F) or
rises above 60°C (140°F). Temperatures outside
of this range will damage your battery. High
temperatures during storage, especially at a high
state of charge, reduces the life of the batteries.
•
When storing the machine, follow the steps listed
in Battery Storage Requirements (page
•
If you are mowing in hot conditions or in sunlight,
the battery may overheat. If this happens,
a high-temperature alert will appear on the
InfoCenter LCD display. In this condition, the
machine no longer operates with the reel engaged
and the machine slows down.
Immediately drive the machine to a cool location
out of the sun, turn off the machine, and allow the
battery to cool fully before resuming operation.
•
Keep the battery pack cover clean. The white
color reflects sunlight and slows the heat buildup
in the battery pack. A dirty cover increases the
heat in the battery pack each day and reduces the
energy capacity.
•
Adjust the bedknife-to-reel contact to be as light
as possible. This reduces the power needed to
run the reel and increases the amount of work the
machine performs on each charge.
3,809 m 2 (41,000 ft 2 )
3,623 m 2 (39,000 ft 2 )
3,252 m 2 (35,000 ft 2 )
3,066 m 2 (33,000 ft 2 )
39).
Understanding the Battery
Charger
Refer to Figure 28
battery-charger displays and cords.
1. Error indicator light
2. USB port cover
3. AC Power indicator light
4. Battery charging indicator
light
5. Charging output indicator
light
Connecting to a Power Source
To reduce the risk of electric shock, this charger has a
3-prong grounded plug (type B). If the plug does not
fit into the wall receptacle, other grounded plug types
are available; contact an authorized Toro distributor.
Do not change the charger or the power supply cord
plug in any way.
28
for an overview of the
Figure 28
6. LCD display
7. Select button
8. Output connector and cord
9. Power-supply cord
g251620
g251632