Installing The Cutting Units; Adjusting The Machine Settings - Toro Greensmaster eTriFlex 3360 Operator's Manual

7

Installing the Cutting Units

Parts needed for this procedure:
Cutting unit (order separately; contact your authorized
3
Toro distributor)
3
Grass basket
3 Electric counterweight
6 Capscrew
3 O-ring
Procedure
1. Prepare the cutting units for installation; refer to
your cutting unit Operator's Manual.
2. Apply grease to the inside spline of the drive
coupler.
3. Install an O-ring to each reel motor as shown
in Figure 11.
4. Secure the electrical counterweight to the
existing counterweight with 2 capscrews as
shown in Figure
Figure 11
12.
1. Capscrew
2. Electrical counterweight
5. Install the cutting units; refer to
Cutting Units (page
6. Install each grass basket onto the grass-basket
hooks.
8
Adjusting the Machine
Settings
No Parts Required
Procedure
Use the InfoCenter to adjust the machine settings;
refer to Using the InfoCenter to Adjust the Machine
Settings (page
g256064
11
Figure 12
3. Existing counterweight
Installing the
50).
24).
g036342