Pre-Maintenance
Procedures
Raising the Machine
DANGER
Mechanical or hydraulic jacks may fail to support the machine and cause a serious injury.
• Use jack stands to support the raised machine.
• Use only mechanical or hydraulic jacks to lift the machine.
1.
Position a jack at the desired jacking point
•
Foot step on the left side of the machine
•
Jack bracket on the right side of the machine
•
Caster fork on the rear of the machine
1. Foot step—left side of the machine
2. Caster fork—rear of the machine
2.
After raising the machine, use an appropriate jack stand under the following areas to support the machine
(Figure
38):
•
Battery trays at the rear of the machine
•
Cutting-unit pivot mounts at the front of the machine
(Figure
37):
Figure 37
3. Jack bracket—right side of the machine
37
g286954