Filling The Fuel Tank; Identifying The Cutting Units - Toro Greensmaster eTriFlex 3360 Operator's Manual

Filling the Fuel Tank

1. Engage the parking brake, shut off the engine,
remove the key, and wait for all movement to
stop.
2. Clean around the fuel-tank cap and remove it
(Figure 29).
Figure 29
1. Fuel tank
3. Add the specified fuel to the fuel tank until the
level is 25 mm (1 inch) below the bottom of the
filler neck. This space in the tank allows the fuel
to expand.
Important:
Do not fill the fuel tank
completely full.
4. Install the cap.
Note:
You will hear a click sound when the cap
is secure.
5. Wipe up any spilled fuel.
g274664
2. Fuel-tank cap
Identifying the Cutting
Units
The InfoCenter uses the numbers 1, 2, and 3 to
identify each cutting unit (e.g., CU1, CU2, and CU3
in the A menu).
BOUT
•
1 refers to the center cutting unit
•
2 refers to the front left cutting unit
•
3 refers to the front right cutting unit
1. Center cutting unit
2. Front left cutting unit
23
(Figure 30)
(Figure
(Figure
Figure 30
3. Front right cutting unit
30)
30)
g289940