Servicing The Engine Oil - Toro Greensmaster eTriFlex 3360 Operator's Manual

5. Loosen the hose clamp and remove the
air-cleaner assembly
6. Carefully pull the foam element off the paper
element (Figure
1. Cover
2. Hose clamp
Cleaning the Foam Air-Cleaner
Element
1. Wash the foam element in liquid soap and
warm water. When the element is clean, rinse
it thoroughly.
2. Dry the element by squeezing it in a clean cloth.
Important:
Do not twist the foam element,
as it may tear.
Replace the foam element if it is torn or worn.
Servicing the Paper Air-Cleaner
Element
1. Clean the paper element by tapping it gently to
remove dust. If it is very dirty, replace the paper
element (Figure
2. Inspect the element for tears, an oily film, or
damage to the rubber seal.
3. Replace the paper element if it is damaged.
Important:
Do not clean the paper filter.
Installing the Foam and Paper
Air-Cleaner Elements
Important:
To prevent engine damage, always
operate the engine with the complete foam and
paper air-cleaner assembly installed.
(Figure 40).
40).
Figure 40
3. Paper element
4. Foam element
40).
1. Carefully slide the foam element onto the paper
element
2. Place the air-cleaner assembly onto the
air-cleaner base or hose and secure it
40).
3. Place the air-cleaner cover into position and
tighten the cover knobs

Servicing the Engine Oil

The engine is shipped with oil in the crankcase;
however, you must check the oil level before and after
starting the engine the first time.
Engine-Oil Specification
API Oil Service Classification: SJ or higher
Oil Viscosity: SAE 30
g012619
Note:
Use any high-quality detergent oil.
Checking the Engine Oil
CAUTION
Engines can become extremely hot during
normal operation.
Allow the engine to cool before you check the
oil or perform any engine maintenance.
Refer to Figure 41
1. Park the machine on a level surface, lower the
cutting units, engage the parking brake, shut off
the engine, and remove the key.
2. Unscrew the dipstick, remove it, and wipe it with
a clean rag.
3. Insert the dipstick into the dipstick tube.
4. Pull the dipstick out of the tube and check the
oil level.
5. If the oil level is low, add oil into the engine
through the dipstick tube until the oil level is up
to the F
ULL
Add the oil slowly and check the level often
during this process.
Important:
oil.
6. Install the dipstick.
39
(Figure 40).
(Figure
for this procedure.
mark on the dipstick.
Do not overfill the engine with
(Figure
40).