Maintenance; Maintenance Safety; Recommended Maintenance Schedule(S) - Toro Greensmaster eTriFlex 3360 Operator's Manual

Maintenance

Maintenance Safety

•
Before you leave the operator's position, do the
following:
– Park the machine on a level surface.
– Move the function-control switch to the
N position.
EUTRAL
– Lower the cutting units to the ground and
ensure that they are disengaged.
– Engage the parking brake.
– Shut off the engine and remove the key.
– Wait for all movement to stop.
•
Allow machine components to cool before
performing maintenance.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 8 hours
After the first 50 hours
Before each use or daily
Every 25 hours
Every 50 hours
Every 100 hours
Every 200 hours
Every 800 hours
Every 1,000 hours
Every 2 years
Maintenance Procedure
• Change the engine oil and filter.
• Torque the wheel nuts.
• Change the traction-motor-gearbox fluid.
• Check the engine speed.
• Inspect the seat belt(s) for wear, cuts, and other damage. Replace the seat belt(s) if
any component does not operate properly.
• Check the safety-interlock system.
• Inspect and cleanup after mowing.
• Check the engine oil.
• Check the tire pressure.
• Check the reel-to-bedknife contact.
• Wash the machine (do not use high-pressure water).
• Clean the foam air-cleaner element (more often in dirty or dusty conditions).
• Check the battery cable connections.
• Check the paper air-cleaner element (more often in dirty or dusty conditions).
• Change the engine oil and filter.
• Replace or clean and gap the spark plug.
• Replace the paper air-cleaner element (more often in dirty or dusty conditions).
• Torque the wheel nuts.
• Change the traction-motor-gearbox fluid.
• Check the engine speed.
• Replace the fuel filter (sooner if the fuel flow is restricted).
• Check the fuel lines and connections.
•
Disconnect the main-power connectors before
performing maintenance.
•
If possible, do not perform maintenance while the
engine is running. Keep away from moving parts.
•
Support the machine with jack stands whenever
you work under the machine.
•
Carefully release pressure from components with
stored energy.
•
Keep all parts of the machine in good working
condition and all hardware tightened.
•
Replace all worn or damaged decals.
•
To ensure safe, optimal performance of the
machine, use only genuine Toro replacement
parts. Replacement parts made by other
manufacturers could be dangerous, and such use
could void the product warranty.
35