Towing The Machine - Toro Greensmaster eTriFlex 3360 Operator's Manual

Towing the Machine

Note:
Refer to Figure 35
Figure 35
1. Nut
2. Spring
3. Spring length—11.4 cm
(4.5 inches)
To tow the machine, you must perform the following
procedure to release the brake actuator:
1. Engage the parking brake.
2. Remove the key and disconnect the main-power
connectors.
Important:
If the main-power connectors are
connected while towing, electrical damage
may result.
3. Close the fuel-shutoff valve.
4. Chock both sides of the front tires.
5. Release tension on the spring by loosening
the nut that secures the eyebolt to the spring
bracket.
6. Remove the spring.
7. Insert a ratchet (3/8 inch) through the hole of the
arm bracket and push in the actuator shaft.
for this procedure.
4. Arm-bracket hole
5. Actuator shaft
DANGER
When the actuator is released from the
brake, the machine is able to free wheel.
A free-wheeling machine can cause
serious injury to bystanders.
If the machine is not being towed, engage
the parking brake.
8. Engage the parking brake.
9. Remove the chocks from the tires.
10. If the 3-Wheel Drive Kit is installed, disconnect
the kit-wire-harness connectors from the main
wire harness.
Important:
harnesses are connected while towing,
electrical damage may result.
11. When the machine is ready to be towed,
disengage the parking brake.
12. Have an assistant sit in the seat, fasten the
seatbelt, and use the brake while you tow the
machine.
g267401
Note:
This ensures that the machine is
under control when you tow the machine over
undulations and slopes.
13. Use the rear castor fork to tow the machine
(Figure 36).
Important:
while towing the machine. Damage to the
electrical components may result.
1. Rear castor fork
33
If the kit and machine wire
Do not exceed 5 km/h (3 mph)
Figure 36
g270135