Driving The Machine Without Engine Power - Toro Greensmaster eTriFlex 3360 Operator's Manual

After you have towed the machine to your intended
destination, perform the following steps:
1. Engage the parking brake.
2. Remove the tow strap from the castor fork.
3. Prepare for operation by tightening the eyebolt
nut so that the spring length is 11.4 cm (4.5
inches) when installed
Driving the Machine
Without Engine Power
You can drive the machine using the battery power
of the machine. This feature can be used for the
following scenarios:
•
Moving the machine in the maintenance shop.
•
Moving the machine off of the green if the engine
shuts off.
The machine can be transported only; you cannot
engage the cutting units. This feature lasts for 1
minute, and you can cycle the key switch to reset the
minute of transport time.
1. Sit in the operator's seat and fasten the seatbelt.
2. Move the key to the O
3. Move the function-control switch to the M
T position.
RANSPORT
4. Disengage the parking brake.
5. Use the traction pedal to transport the machine.
Note:
Forward ground speed is limited to 4.8
km/h (3.0 mph), and reverse ground speed is
limited to 4.0 km/h (2.5 mph).
Important:
Excessive or prolonged use of this
feature may decrease the life of the batteries.
(Figure 35).
position.
N
OW
or
34