Toro Greensmaster eTriFlex 3360 Operator's Manual page 51

Figure 63
1. Footrest—closed
3. Position the cutting unit under the center
suspension arm.
4. Open the latches on the suspension-arm bar
(Figure 64) and push the suspension arm down
so that the bar fits over both pitch arms on
the cutting unit and ensure that the latches go
underneath the cutting-unit crossbar
Figure 64
1. Latch—closed
2. Suspension-arm bar
Figure 65
1. Suspension-arm bar
g014602
2. Footrest—open
(Figure 65).
g014609
3. Latch—open
g036343
2. Cutting-unit bar
5. Close the latches down and around the
cutting-unit bar and lock them in place
64).
Note:
You can hear a click and feel when the
latches are properly locked in place.
6. Coat the spline shaft of the cutting unit motor
with clean grease
7. Insert the motor into the left side of the cutting
unit (as viewed from the operator's position) and
pull the motor retaining bar on the cutting unit
toward the motor until you hear a click from both
sides of the motor
1. Reel motor
2. Spline shaft
8. Mount a grass basket onto the basket hooks on
the suspension arm.
9. Repeat this procedure for the other cutting units.
10. Connect the main-power connectors; refer to
Main-Power Connectors (page
51
(Figure 66).
(Figure 66).
Figure 66
3. Cavity
4. Motor-retaining bar
20).
(Figure
g036122