Adjusting The Beam Axis - Panasonic HG-T Series User Manual

Notes 1): The beam axis adjustment indicator on the sensor head receiver does not light up
during measurement mode.
2): The HG-T1110 is not equipped with beam axis adjustment indicators. Therefore, when the
HG-T1110 is used, the beam axis cannot be checked using the sensor head.
● If the beam axis of the sensor head is misaligned, refer to
adjust the beam axis.
If you confirm that the beam axis has been aligned, proceed to "Reference Waveform
Registration".
■
How to return to measurement mode
You can return to measurement mode by pressing the
controller.

5.3.2 Adjusting the Beam Axis

Invoke beam axis adjustment mode and check the state of the beam axis by using the display
unit of the controller or the beam axis adjustment indicators on the sensor head receiver
(except for HG-T1110).
■
Checking the beam axis on the display unit of the controller
Example: The emitter is too low with respect to the receiver.
First, when adjusting the beam axis, select whether adjustment will be performed by moving
the emitter or the receiver with the
When "HEAD-E" (emitter base) is selected
An arrow is displayed from "B" to "T".
Move the emitter to the TOP side and adjust it.
WUME-HGT-6
5.3 Explanation of Basic Operation

"5.3.2 Adjusting the Beam Axis"

key on the operation unit of the
/ key of the controller.
When "HEAD-D" (receiver base) is selected
An arrow is displayed from "T" to "B".
Move the emitter to the BOTTOM side and adjust it.
and
5-9