Flow Of Measurement Data - Panasonic HG-T Series User Manual

6.1 Flow of Measurement Data

6.1 Flow of Measurement Data

For controllers, up to 15 slave units can be connected to a master unit. (Up to 14 slave units
can be connected if a communication unit is connected.) Each controller can perform
measurements independently and measured values can be calculated between controllers.
Each function is executed as shown in the following flowchart.
Example: When one master unit and two slave units are connected and calculation
application selection "THICK" (thickness/width measurement) and independent
measurement are used at the same time <When the master unit and slave unit 1
perform calculations and slave unit 2 performs independent measurement>
(Note 1) When calculation mode is selected, the number of slave units performing calculations varies according
to the calculation application selection settings.
6-2 WUME-HGT-6