Table of Contents
Advertisement
No.
Operation mode
1-a
(OP.MODE)
Measurement direction
1-b
(DIRECT)
Average count (response
time)
1-c
(SPEED)
● The key operation (for the
applies to the
■
Function selection [Basic settings]
No.
-
Initial screen
2
Basic settings
HIGH set value
2-a
(HI.SET)
LOW set value
2-b
(LO.SET)
WUME-HGT-6
Item
Display screen
key) for returning to the setting mode selection screen also
key.
Item
Display screen
6.2 Setting Operation List
Function
This function allows you to set an operation
mode according to the use of the measurement
method for the object to be measured.
<Default: AT.EDGE>
This function allows you to set the insertion
direction of the measured object to the TOP or
BOTTOM side.
<Default: TOP>
This function allows you to set the time period
(response time) from when the sensor head
starts measurement until a judgment value
(JUDGE.V) is finalized and a judgment is
output.
The response time differs depending on
whether the sampling cycle is high-speed
sampling or standard sampling.
<Default: 32>
Function
This function allows you to manually set the
HIGH set value (upper limit value) to any
desired value.
<Default: 5.000>
This function allows you to manually set the
LOW set value (lower limit value) to any desired
value.
<Default: 1.000>
-
-
Refere
nce
page
"P.
6-9"
"P.
6-10"
"P.
6-11"
Refere
nce
page
-
-
"P.
6-14"
"P.
6-15"
6-5
Advertisement
Table of Contents
