Operation Mode; Auto Edge Detection Mode ( ) - Panasonic HG-T Series User Manual

5.4 Operation Mode

5.4 Operation Mode

■
Overview
You can set an operation mode according to the measurement method for the object to be
measured.
● Auto edge detection mode (
● Edge detection mode (
● Outer diameter / width detection mode (
● Inner diameter / gap detection mode (
● Central position detection mode (
● User assigned edge detection mode (
For the setting procedure for each operation mode, refer to
5.4.1 Auto Edge Detection Mode (
This mode automatically recognizes the direction in which the measured object enters the
measurement area of the sensor head (TOP or BOTTOM side). The distance from the edge of
the side where the measured object enters the measurement area to the edge of the measured
object is measured.
When the measured object enters the measurement area from the TOP side
On the basis of the TOP side, the distance from the TOP side edge to the edge of the
measured object is detected as the measured value.
When the measured object enters the measurement area from the BOTTOM side
On the basis of the BOTTOM side, the distance from the BOTTOM side edge to the edge of
the measured object is detected as the measured value.
5-22
)
)
)
)
)
)
)
"6.3.1 Operation Mode ( )".
WUME-HGT-6