Measurement Direction - Panasonic HG-T Series User Manual

6.3 Detection Settings (
Setting item

6.3.2 Measurement Direction (

This function sets the insertion direction of the measured object to the TOP or BOTTOM side.

Measurement direction

TOP (TOP)
BOTTOM (BOTTOM)
When set to TOP
When set to BOTTOM
● When the operation mode (OP.MODE) is set to auto edge detection mode (AT.EDGE), outer
diameter / width detection mode (OUT.WD), inner diameter / gap detection mode (IN.GAP), or
user assigned edge detection mode (USR.EDG), the measurement direction is displayed as
" ".
6-10
)
Edge detection mode (EDGE)
Outer diameter/width detection mode (OUT.WD)
Inner diameter/gap detection mode (IN.GAP)
Central position detection mode (CEN.POS)
User assigned edge detection mode (USR.EDG)
)
When the measured object is inserted from the TOP side
When the measured object is inserted from the BOTTOM side
Setting range
Function
Default value
WUME-HGT-6