Storing Scan Operations (Programs) - Sharp MX-B382 Operation Manual

STORING SCAN OPERATIONS (Programs)

A destination, original settings, and functions can be stored in a program. When you wish to use those settings to send
an image, they can be retrieved with ease.
For example, suppose A4 (8-1/2" x 11") size documents are scanned into a file and sent to each branch office once a month.
(1) The same documents are sent to each branch office
(2) Smudges on the edges of the documents are erased before transmission
When a job program is not stored
Enter the address of each branch office.
Select Erase settings.
Press the [START] key.
The originals are scanned and transmitted.
Considerable time is required to send the documents each
month because the above settings must be selected.
In addition, mistakes may occasionally be made when
selecting the settings, so incorrect transmissions may occur.
• Programs are stored, edited, and deleted using "Address Control" in the system settings. See "Program" (page
7-23) in "7. SYSTEM SETTINGS".
• Programs can also be stored in the Web pages. Click [Job Programs] and then [Image Send] in the Web page menu.
• The settings stored in a program will be retained even after the program is used for transmission. The same settings can
be used repeatedly for transmission.
• The following settings can be stored in programs.
• Image send mode: Scan, Internet fax
• Destinations
• Image settings: Original scan size, original orientation, duplex scanning, exposure, resolution
• Special modes: Erase, Suppress Background, Job Build, Slow Scan Mode, Mixed Size Original, Business Card Scan,
Original Count
• Preview function
• Up to 48 programs can be stored.
• Up to 500 destinations can be stored in one program.
• This function cannot be used in USB memory mode or data entry mode.
Place the original.
Place the original in the document feeder tray or on the document glass as appropriate for the functions stored in the program.
1
When the original is a different size than the size setting, set the original size.
☞
SPECIFYING THE ORIGINAL SCAN SIZE AND SEND SIZE
When a job program is stored
Touch a stored program key.
Press the [START] key.
The originals are scanned and transmitted.
When a program is used, settings are selected with ease by
simply pressing the stored key.
In addition, transmission takes place based on the stored
settings so there are no chances for mistakes.
(page 5-56)
5-76
SCANNER/INTERNET FAX
Contents