Sharp MX-B382 Operation Manual page 189

• System Settings (Administrator): Default original size setting
Set this if you frequently use a particular original size. The set size will appear in the [Original] key.
When this setting is configured, changing the original size can be omitted.
• System settings (Administrator): Setting of Default Original Exit Place (MX-B382SC Only)
When the automatic document feeder is used, the original's default output destination can be set to the upper exit or the
heavy exit. (Except when "Size Input" or "Card Size" is selected for the original size.)
MX-B382SC Only
• In the situations below, the original exit place is fixed to the heavy exit.
- When "Card Size" is selected
- When the original guide is set to 74 mm (2-7/8") or lower (Except when "Check Size" is selected)
- When the automatic document feeder is scanning an original with an X (horizontal) value of 105 mm (4-1/8") or less
• When "Card Size" is selected, you cannot copy if the original guide is set to 74 mm (2-7/8") or higher.
Specifying a non-standard original size
Original
A5 216x330
1
B5 216x340
A4 216x343
Size Input
OK
16K
AB
Inch
Custom Size None
2-30
Touch the [Size Input] key.
COPIER
Contents