Document Feeder - Sharp MX-B382 Operation Manual

Auto Selection of Paper Tray that
was Last Loaded
When this setting is enabled and the machine is on
standby in copy mode, the last paper tray that was
loaded with paper automatically becomes the default
paper tray for copy mode, until the machine is reset.
600dpi x 600dpi Scanning Mode for

Document Feeder

This is used to change the scanning resolution for
copying using the automatic document feeder from 600 x
300 dpi to 600 x 600 dpi (high quality mode).
When high quality mode is used, fine print and thin lines
are reproduced with greater clarity, however, the
scanning speed is slower.
When high quality mode is not selected, the following
conditions must be satisfied in order to scan at 600 x
300 dpi and attain the fastest speed.
• The copy ratio must be set to 100%.
• Do not select a special mode that will change the
ratio.
Quick Scan from Document Glass
This is used to change the scanning resolution for
copying using the document glass from 600 x 600 dpi to
600 x 300 dpi (speed priority mode).
When high speed mode is selected, the first copy time is
quicker, however, the copy image is not as clear.
When high speed mode is selected, the following
conditions must be satisfied in order to scan at 600 x
300 dpi and attain the fastest speed.
• The copy ratio must be set to 100%.
• Do not select a special mode that will change the
ratio.
Auto Clear Before Copy Job
Execution
When configuring copy settings, Auto Clear can be
activated even if the copy job is not complete.
This prevents situations whereby the machine is left
unattended with an uncompleted copy job.
7-74
SYSTEM SETTINGS
Contents