Table of Contents
Advertisement
Using the Tool Analog Inputs, Differential
The example below shows how to connect an analog sensor with a differential output. Connect
the negative output part to GND (0V) and it works in the same way as a non-differential sensor.
1.9.5. Ethernet
An Ethernet connection is provided at the bottom of the control box, see illustration below.
The Ethernet interface can be used for the following:
• MODBUS I/O expansion modules. See more in
• Remote access and control.
The electrical specifications are shown below.
Parameter
Communication speed
1.9.6. Mains connection
The mains cable from the controller box has a standard IEC plug in the end. Connect a country
specific mains plug or cable to the IEC plug.
In order to energize the robot, the control box must be connected to the mains. This must be
done through the standard IEC C20 plug at the bottom of the control box through a corresponding
IEC C19 cord, see illustration below.
User Manual
POWER
AI2
AI8
GND
POWER
AI8
AI2
GND
part Part II PolyScope Manual on
Min
Typ
10
-
45
page 85.
Max
Unit
1000
Mb/s
UR10
Advertisement
Table of Contents
