To build a main vector sequence
During a single run, the program vectors in the MAIN SEQUENCE are output
to the system under test in an order of first vector to last vector. The data of
the last vector is then held until run is selected again. During a repetitive
run, the MAIN SEQUENCE loops until stop is selected.
From the Sequence menu, use the knob to highlight the first data row.
1
Select the Insert field once for each line of vectors you want inserted
2
into the main sequence.
These new lines of vectors provide fields to place data into for each label.
Select the data field, then type in a data value.
3
If you will be adding data in many fields, use the Autoroll feature. Refer to
"To use Autoroll" later in this chapter.
Using the Pattern Generator
To build a main vector sequence
5–7