To Add Sequence Levels - HP 1660CP Series User Manual

Using the Trigger Menu

To add sequence levels

To add sequence levels
You can add sequence levels anywhere except after the final one.
In the Trigger menu, select the number beside the sequence level just
1
after where you want to insert.
For example, if you want to insert a sequence level between levels 1 and 2,
you would select level 2. To insert levels at the beginning, select level 1.
A Sequence Level pop-up appears. Its exact contents depend on the analyzer
configuration and the level specification. However, all Sequence Level
pop-ups have an Insert Level field in the upper left corner.
Select Insert Level.
2
Another pop-up offers the choices of Cancel, Before, or After. If the level you
started from was the last level, After will not appear.
Select Before.
3
The Trigger Macro pop-up replaces the Sequence Level pop-up. The macros
available depend on whether the analyzer is configured as state or timing.
Use the knob to highlight a macro, and select Done.
4
A new Sequence level pop-up appears. Its contents reflect the macro you just
selected. The figure below shows a user macro for a state analyzer.
Fill in the fields and select Done.
5
Sequence Level Pop-up Menu
4–8