HP 1660CP Series User Manual page 105

When deleting vector rows, the INIT START, INIT END, MAIN START, and
MAIN END cannot be deleted. Deleting all the vector rows from INIT START
to MAIN END will reset the sequence to the powerup state. The deletion will
not be performed if the results of the delete operation will place fewer than
two vectors in the main sequence, or, if the delete operation will place an
instruction on any of the following vectors:
•
The first vector of the INIT sequence.
•
The first vector of the MAIN sequence.
•
The last vector of the MAIN sequence.
•
The vector prior to the IF block.
•
The first vector of the IF block.
•
The last vector of the IF block.
•
The vector following the IF block.
Merge
Selecting the Merge field brings up a pop-up menu that lets you select
sections of a previously created configuration file to merge after the current
line in the sequence. The Input Drive field selects between the hard disk or
the front floppy disk (if present). The Filename field displays a file browser
pop-up menu that allows searching for the file to be used in the merge. The
Merge Section field lets you select the section of the configuration to be
merged. Configuration sections consist of the main sequence and any macros
that were created. The merge will not be performed in the following cases:
•
Merge data exceeds the maximum number of sequence lines.
•
Merge data requires more repeats than are available.
•
Merge data requires more macro calls than are available.
Using the Pattern Generator
The Sequence Menu
5–29