HP 1660CP Series User Manual page 245

System Performance Analysis (SPA) Software
Getting started
Setting up the State Format specification
When a State or Timing analyzer is changed to SPA, SPA will retain the State
or Timing Format specification. For complete details on changing from a
State or Timing Analyzer to SPA, see "Using SPA with other features."
The State and Timing format specification menus provide symbol tables. You
can use any defined symbols to specify the Low and High values in State
Overview to define the ranges and the qualified states in State Histogram, or
to specify the Start and End conditions in Time Interval.
Your ability to use existing State or Timing configurations with SPA depends
on your application and target system. If your SPA measurement uses the
same physical signals from the target system as an existing State or Timing
configuration, it may be easier to load the state or timing configuration from
the disk instead of entering a new one.
This manual assumes you already have a basic understanding of the Analyzer
Format menu, and it will not be covered here.
Default SPA Menu
9-7