Nortel Meridian 1 Option 11C Manual page 80

Page 80 of 126 DTI Maintenance
553-3011-315 Standard 13.00
Table 24
Self-test failure codes for NTAK10 2.0 Mb DTI (Part 4 of 5)
148 = The TN of MESSOUT 29 received was not that of
TS 0.
149 = Upon enabling the DTI card, the CI-1 was unable
to write Frame 0, TS 16 with '0B'.
150 = MESSOUT 26 was received with the PPM counting
bit (abcd) all equal to zero.
151 = MESSOUT 28 was received with the outpulsing bit
(abcd) equal to zero.
152 = CI-2 failed to respond to the CI-1 watch dog
message.
153 = The CI-2 failed to respond to five consecutive
watchdog
154 = Messout received requesting the lower nibble of
MFAS
'0000'.
155 = MESSOUT received requesting '0000' to be written
into an 'abcd' state.
156 = MESSOUT received with a TN outside the range
shelf 0, card 8-1
DTI009C ch DTI009 error codes for CI microprocessor (M=C):
157 = CI-1, NI FIFO overflowed, and has been cleared.
128 message were lost.
255 = TS16-DS30X FIFO overflowed, and has been
cleared. 128 messages were lost.
147 = The TN of MESSOUT 28 received was not that of
TS 0.
148 = The TN of MESSOUT 29 received was not that of
TS 0.
January 2002
messages and is assumed to be out of service.
pattern to be written with something other than
unit 3-0.