Nortel Meridian 1 Option 11C Manual page 79

Table 24
Self-test failure codes for NTAK10 2.0 Mb DTI (Part 3 of 5)
132 = Attempt was made to enable outpulsing TS 0 or
TS16.
133 = A Messout 31 has been received for TS 0 or TS 16
with the pulse hold time not = 0.
134 = An attempt has been made to set the bit to invoke
the pulse timer for TS 0 or TS 16.
135 = A request for outpulsing was received, but
outpulsing data was not downloaded.
137 = A request for PPM counting was received, but the
was not downloaded.
138 = A Messout 30 was received requesting a task to be
DTI009C ch DTI009 error codes for CI microprocessor (M=C):
139 = The 8031 on CHIP RAM failed self test.
140 = The TS 16 signaling RAM and/or the TS 16 pick up
buffer failed self test.
141 = The CI-1 micro external RAM failed self test.
142 = Attempt was made to set/clear the flag used to
invoke
143 = CI-2 micro responded to echo request message
but response was in error.
144 = CI-2 micro failed to respond to request echo
message.
145 = The request for self test received did not have the
TN of TS 0
146 = The TN of MESSOUT 26 received was not that or
TS 0.
147 = The TN of MESSOUT 28 received was not that of
TS 0.
DTI Maintenance
performed for DTI TS 16 which is not allowed.
PPM pulse timing for DTI timeslot 0 or 16.
Page 79 of 126
Option 11C 2.0 Mb DTI/PRI