Nortel Meridian 1 Option 11C Manual page 56

Page 56 of 126 2.0 Mb PRI Implementation
Prompt Response
USR PRI
IFC xx
DCHL xx
PRI2 <CR>
OTBF 1-(16)-127
SIDE NET (USR)
RLS XX
RCAP MSL
OVLR <CR>
LAPD YES (NO)
- T23 1-(20)-31
T200 2-(3)-40
- N200 1-(3)-8
553-3011-315 Standard 13.00
Description
D-channel is for ISDN PRI only.
Note: 2.0 Mb only supports PRI or SHA user mode.
Interface type.
PRI card number which will be carrying the D-channel. Must
match entry made for the "CDNO" associated with the
"DCHI" prompt above.
xx = 1-9 for main cabinet, 11-19 for IP expansion cabinet1,
21-29 for IP expansion cabinet 2, 31-39 for IP expansion
cabinet 3, and 41-49 for IP expansion
cabinet 4.
Additional PRI Loops controlled by this DCHI. Remember
one DCHI can control up to 16 PRI loops going to the same
destination. For the Option 11C system, the maximum limit
is eight loops.
Number of output request buffers. Note: for a single PRI link,
leave this prompt at default (16). Add 5 output request
buffers per additional link.
Prompted only if IFC is set to SL1.
NET = network, the controlling switch
USR = slave to the controller
Software release of far-end. This is the current software
release of the far end. If the far end has an incompatible
release of software, it prevents the sending of application
messages, e.g. for Network Ring Again.
MSDL RCAP capability.
Allow or disallow overlap receiving on a D-channel. Default
is NO.
Change LAPD parameters. Enter carriage return if timers
are to be left at default. The following timers are prompted
only if LAPD is set to YES. (They can all be left at default
during initial set-up.)
Interface guard timer checks how long the interface takes to
respond. In units of 0.5 seconds (default 20 = 10 seconds).
Retransmission timer in units of 0.5 seconds (default 3 = 1.5
seconds).
Maximum number of retransmissions
January 2002