Nortel Meridian 1 Option 11C Manual page 23

LD 73 – Define the 2.0 Mb DTI pad tables.
Prompt Response
REQ NEW
CHG
TYPE DTI2
FEAT PAD
PDCA 1-16
TNLS YES (NO)
DFLT (1)-16
The following prompts define the pad levels.
The receiving pad code is r and the transmission pad code is t. These entries have the range
0-15. The pad values (in decibels) relating to these codes are shown after this table.
ONP r t
OPX r t
DTT r t
SDTT r t
NTC r t
TRC r t
DCO r t
VNL r t
DTO r t
ACO r t
AFX r t
ADD r t
SATT r t
TNLS YES (NO)
2.0 Mb DTI Implementation
Description
Add or change Digital Trunk Interface data block
2.0 Mb DTI
Request the digital pad feature.
PAD Category table.
If one channel is using the specified table, then the command
is aborted.
Table 1 cannot be modified or deleted.
TN List. This is for the print command only.
A YES response means that a list of the trunk TNs using the
requested PAD category tables will be printed after the table.
For NEW only. The table is used for default values.
On-premises extension
Off-premises extension
Digital TIE trunks
Digital Satellite TIE trunks
Nontransmission compensated
Transmission compensated
Digital COT, FEX, WAT, and DID trunks
Via Net Loss
2.0 Mb DTI digital TOLL office trunks
Analogue CO or WATS trunks
Analogue FEX trunks
Analogue DID trunks
Analogue satellite TIE trunks
TN List. This is for the print command only.
A YES response means that a list of the trunk TNs using the
requested PAD category tables will be printed after the table.
Page 23 of 126
Option 11C 2.0 Mb DTI/PRI