Nortel Meridian 1 Option 11C Manual page 19

Prompt Response
N
P EOSF(S) abcd
N
TIME (100)-150
P EOSB(S) abcd
N
TIME (100)-150
P OPCA(R) abcd
N
TIME 64-(128)-192
REPT (1)-5
CONN(S) abcd
CONN(R) abcd
P RRC(S) abcd
N
TIME 10-(100)-150
P BURS(S) abcd
N
P BURS(R) abcd
N
TIME 64-(128)-192
P CAS(S) abcd
N
CLRB(S) abcd
N
P RCTL(S) abcd
2.0 Mb DTI Implementation
Description
If NRCV(S) signal not required
End of selection free (send)
If EOSF(S) not required
Time for EOSF(S) in milliseconds
End of selection busy (send)
If EOSB(S) not required
Time for EOSB(S) in milliseconds
Operator calling time (receive) signal
If OPCA(R) not required
Time of OPCA(R) pulse in milliseconds
Number of OPCA(R) pulses.
Connect send
Connect receive
Register recall (send) signal. Activated by Malicious Call
Trace.
If RRC(S) not required
Time of RRC(S) signal in milliseconds
Bring up receiver (send). Uses switch-hook flash timer for
timer.
If BURS(S) not required
Bring up receiver (receive). Uses switch-hook flash timer for
timer.
If BURS(R) not required
Length of BURS(R) pulse in milliseconds
CAS Flash. Same timing as analogue trunks.
Note: Prompted for JDMI only. Operational only if CASM
package equipped.
If CAS(S) not required
Clearback (send) signal.
If CLRB(S) not required (IDLE signal is used).
Release control (send) signal.
Page 19 of 126
Option 11C 2.0 Mb DTI/PRI