Teldat H1+ Installation Manual page 28

1 Installing the Router
Gateway IP address
Run from flash/host (f/h)
Default host run file name
Default host flash file name
Boot delay (0-9 seconds)
Boot image (0=latest, 1=previous) : 0
Board Id (0-1)
Number of MAC Addresses (1-32)
Base MAC Address
PSI Size (1-64) KBytes
Main Thread Number [0|1]
DHCP running
*** Press CTRL+T to stop DHCP and break into CFE menu ***
*** Press CTRL+T to stop auto run (3 seconds) ***
Auto run second count down: 0
Booting from only image (0xb8160000) ...
Code Address: 0x80010000, Entry Address: 0x802f8000
Booting version 10.08.06
Decompression OK!
Entry at 0x802f8000
Closing network.
Disabling Switch ports.
Flushing Receive Buffers...
19 buffers found.
Closing DMA Channels.
Starting program at 0x802f8000
CIT software version: 10.08.06
Current software license: 26 48
S/N: 728/00132
=== INITIAL
a) Set Date and Time
d) Change Licence
f) Disk menu
l) Load from lan
r) Reset
v) Change version control for loading
0) Exit
>>
• The device is now in BIOS mode with the IP configuration established in BOOT (default: IP address 192.168.1.1
and mask 255.255.255.0).
• You can execute a telnet to access the BIOS menu. Once you've done that you enter in the BIOS menu:
CIT software version: 10.08.06
Current software license: 26 48
S/N: 728/00132
=== INITIAL
a) Set Date and Time
d) Change Licence
f) Disk menu
l) Load from lan
24
:
: f
:
:
: 3
: 96369H1P
: 4
: 00:a0:26:74:00:80
: 24
: 0
MENU ===
MENU ===
Teldat S.A.
Teldat H1+/H1+GE