If The Ethernet Cable Isn't Poe; If The Ethernet Cable Is Poe - Teldat H1+ Installation Manual

1 Installing the Router
• Direct exposure to sunlight should be avoided as well as other heat sources. The device should not be placed
amongst papers, magazines or other elements that could hinder natural air circulation.
• The device should not be placed very close to strong electromagnetic fields such as speakers, engines, etc.
• Knocks and/or strong vibrations should be avoided during transport, operation and storage.
Warning
The electric current in power cables, telephone lines and communication cables is dangerous. To pre-
vent electric shocks, before installing, handling or opening the equipment covers, connect and discon-
nect the cables as follows:

1.2.1 If the Ethernet cable isn't POE

To Connect
Make sure that the device power switch is in the OFF po-
sition (0)
Check that the power supply is not connected to either
the main electricity supply or the device
Connect all data cables
Connect the power supply to the device
Connect the power supply to the main electricity supply
Place the device power switch in the ON position (1)

1.2.2 If the Ethernet cable is POE

To Connect
Note
Power supply through the POE Ethernet cable is independent from the device license.
6
To Disconnect
Place the device power switch in the OFF position (0)
Disconnect the power supply from the main electricity
supply
Disconnect the power supply from the device
Disconnect the data cables
To Disconnect
Teldat S.A.
Teldat H1+/H1+GE