Teldat H1+ Installation Manual page 24

1 Installing the Router
Note
When the RST pushbutton is released, a message similar to the one shown below will appear on the
configuration console.
CFE version XXXX
Build Date: XXXX
Parallel flash device: name AM29LV320MT, id 0x2201, size 16384KB
CPU type 0x2A031: 400MHz, Bus: 160MHz, Ref: 64MHz
CPU running TP0
Total memory: 67108864 bytes (64MB)
Boot Address 0xb8000000
*** default configuration required ***
Board IP address
Host IP address
Gateway IP address
Run from flash/host (f/h)
Default host run file name
Default host flash file name
Boot delay (0-9 seconds)
Boot image (0=latest, 1=previous) : 0
Board Id (0-1)
Number of MAC Addresses (1-32)
Base MAC Address
PSI Size (1-64) KBytes
Main Thread Number [0|1]
DHCP running
*** Press CTRL+T to stop DHCP and break into CFE menu ***
*** Press CTRL+T to stop auto run (1 seconds) ***
Auto run second count down: 0
Booting from only image (0xb8160000) ...
Code Address: 0x80010000, Entry Address: 0x802f8000
Booting version 10.08.06
Decompression OK!
Entry at 0x802f8000
Closing network.
Disabling Switch ports.
Flushing Receive Buffers...
17 buffers found.
Closing DMA Channels.
Starting program at 0x802f8000
CIT software version: XXXXX
Current software license: 26 48
S/N: 706/XXXXX
........
Default configuration used
Parsing text mode configuration ...
Configuration parsed
Initializing
Press any key to get started
20
: 192.168.1.1:ffffff00
: 192.168.1.100
:
: f
:
:
: 3
: 96369H1P
: 4
: 00:a0:26:74:00:80
: 24
: 0
Teldat S.A.
Teldat H1+/H1+GE