gefran ADV200-HC Instruction Manual page 51

Bring hook to a "known
position" and write distance
(expressed in meters)
between hook and rope
winder drum or from pulleys,
if present (C) in "H&C
SERVICE \ Known position"
parameter (IPA 11198).
This operation lets
software calculate its position
on the rope.
On Hoist only: If distance is
not known, see chapter
"Calculation of rope length"
and enter the result in the
"known position" parameter.
In the "H&C SERVICE
\Measure load" parameter
(IPA11200), enter
distance between the hook
groove and the hypothetical
center of gravity of the load
(D).
Save and reset the drives.
Movements of the hook (trolley or beam) with the drive off will cause misalignment between the
real position and the position specified by the drive, making it necessary to repeat the rope
length definition procedure.
ADV200-HC Manual
the
the
D
C
C
Page 51 of 55