gefran ADV200-HC Instruction Manual page 46

Specify digital/analog inputs and outputs
to read and control main system
components
4
Specify the type of joystick to use
5
Specify if the joystick ZERO position
6 contact is present.
Specify if the brake is wired and has to
7
be managed by the drive.
Specify the type of brake feedback
8
contact (NONE, NC, NO).
If brake is present (Brake = ON;
IPA11114), set thresholds for brake
opening.
9
If brake is not present, specify only the
delay for brake opening (OPEN delay;
IPA11138)
Specify if the limit switch contacts are
10
wired and the type.
Specify multispeeds of commands
received.
If digital (JSTK SPEED TYPE; IPA
11062) set all 4 parameters.
11
If analog (JSTK SPEED TYPE; IPA
11062), set only first parameter (SPEED
1; IPA 11004) as maximum commanded
speed.
Configure FastLink address on each
drive, setting drive ..-ELS-VM (or ...-HL-
M) to 1 followed by other drives ...-ELS
(or ...-HL-S).
Set only
Only on drive ELS-VM (or ...-HL-M),
for drives
specify which slave drive ...-ELS (or ...-
..-ELS-..
HL-S) the master should interrogate.
and
Given that the parameter is bit-coded,
..-HL-.. write:
1: if only one slave is connected
3: if two slaves are connected
7: if three slaves are connected
Save and reset the drive.
On the HOIST drive, check that when the FWD command is given the hook moves up and that there is a
positive speed reference.
12
Run rope length definition procedure
13 As an alternative, enter mechanical ratio
"Mpr" directly, bring hook (Trolley or
ADV200-HC Manual
HOIST&CRANE \ DIGITAL INPUTS
26.12
HOIST&CRANE \ ANALOG INPUTS
26.14
ADV200 HO \ DIGITAL OUTPUTS
26.13
HOIST&CRANE \ H&C SERVICE \ Decodifica Jstk
26.02.02
HOIST&CRANE \ H&C SERVICE \ Jstk zero position
26.02.04
HOIST&CRANE \ H&C SERVICE \ Brake
26.02.06
HOIST&CRANE \ H&C SERVICE \ brake fdk
26.02.07
HOIST&CRANE \ ALARM CONFIG
HOIST&CRANE \ H&C SERVICE \ Limit switch
26.02.08
HOIST&CRANE \ CMD SPEED \ Speed 1(..4)
26.04.01(..04)
COMMUNICATION\FL address
23.08.01
COMMUNICATION\FL N of slave
23.08.03
HOIST&CRANE \ H&C SERVICE \ Define axis length
26.02.10
HOIST&CRANE \ H&C SERVICE \ Mpr
26.02.11
11060
11064
11114
11122
11142
11004
11006
11010
11054
5702
5820
11146
11148
Page 46 of 55