Apply Firewall Rules To Pepvpn Traffic; Intrusion Detection And Dos Prevention - peplink Pepwave MAX Series User Manual

Event Logging
Click Save to store your changes. To create an additional firewall rule, click Add Rule and
repeat the above steps.
To change a rule's priority, simply drag and drop the rule:
● Hold the left mouse button on the rule.
● Move it to the desired position.
● Drop it by releasing the mouse button.
If the default inbound rule is set to Allow for NAT-enabled WANs, no inbound Allow firewall rules will
be required for inbound port forwarding and inbound NAT mapping rules. However, if the default
inbound rule is set as Deny, a corresponding Allow firewall rule will be required.

19.1.2 Apply Firewall Rules to PepVpn Traffic

When this option is enabled, Outbound Firewall Rules will be applied to PepVPN traffic. To turn
on this feature, click

19.1.3 Intrusion Detection and DoS Prevention

Pepwave routers can detect and prevent intrusions and denial-of-service (DoS) attacks from
the Internet. To turn on this feature, click
https://www.peplink.com
to Deny, the matching traffic does not pass through the router (and is discarded).
This setting specifies whether or not to log matched firewall events. The logged
messages are shown on the page Status>Event Log. A sample message is as
follows:
Aug 13 23:47:44 Denied CONN=Ethernet WAN SRC=20.3.2.1
DST=192.168.1.20 LEN=48 PROTO=TCP SPT=2260 DPT=80
●
CONN: The connection where the log entry refers to
●
SRC: Source IP address
●
DST: Destination IP address
●
LEN: Packet length
●
PROTO: Protocol
●
SPT: Source port
●
DPT: Destination port
, check the Enable check box, and press the Save button.
Tip
, check the Enable check box, and press the
169 Copyright @ 2020 Pepwave