Unpacking And Connecting; Unpacking The Machine; Transport; Installation And Assembly - Optimum OPTImill MH 50G Operating Manual

Hide thumbs Also See for OPTImill MH 50G:
Table of Contents

Advertisement

OPTIMUM
M A S C H I N E N - G E R M A N Y
3

Unpacking and connecting

3.1

Unpacking the machine

Install the machine close to its final position before unpacking. If the packaging shows signs of
having possibly been damaged during transport, take the appropriate precautions to prevent
the machine being damaged when unpacking. If damage is discovered, the carrier and/or ship-
per must be notified immediately so the necessary steps can be taken to register a complaint.
Examine the complete machine carefully and check whether all materials, such as shipping
documents, instructions and accessories have been delivered with the machine.
3.2

Transport

Centres of gravity
Load suspension points
(Marking of the positions for the load suspension
gear)
Prescribed transport position
(Marking of the top surface)
Means of transport to be used
Weights
WARNING!
Severe or fatal injuries may occur if parts of the machine tumble or fall down from the
forklift truck or from the transport vehicle. Follow the instructions and information on
the transport box.
WARNING!
The use of unstable lifting and load suspension equipment that might break under load
can cause severe injuries or even death. Check that the lifting and load suspension gear
has sufficient load-bearing capacity and that it is in perfect condition. Observe the
accident prevention regulations issued by your Employers Liability Insurance
Association or other supervisory authorities applicable to your company. Fasten the
loads carefully. Never walk under suspended loads!
3.3

Installation and assembly

3.3.1 Installation site requirements

The power plug of the milling machine must be readily accessible.
The illumination of the workplace must be designed in such a manner that an illumination of
500 Lux is attained at the tool tip.
If this is not guaranteed with the normal installation site lighting, workplace lights (available as
an option) must be used.
In order to achieve sufficient safety against falls by slipping, the accessible area in the mechani-
cal machining zone of the machine must be equipped with a slip resistance. The slip-resistant
mat and/or slip-resistant flooring must be at least R11 in accordance with BGR 181.
The used shoes must be suitable for being used in those machining areas. The accessible sur-
faces must be cleaned.
Organize the working area around the milling machine according to the local safety regulations.
The work area for operation, maintenance and repair must not be restricted.
GB
MH50G│MH50V
Page 22
Translation of the original instructions
Version 1.0.1 dated 2017-08-10

Advertisement

Table of Contents
loading

This manual is also suitable for:

Optimill mh 50v33381803338185

Table of Contents