Sharp MX-2314N Service Manual page 237

62-14
Purpose Data clear
Function (Purpose) Used to delete the document filing manage-
ment data.
Section HDD
Operation/Procedure
1) Press [EXECUTE] key.
2) Press [YES] key.
The document filing management data are cleared.
At the same time, the job log data are also cleared.
This simulation is executed in the following trouble cases.
* The document filing function does not work normally.
* The job log is not recorded normally.
This simulation may not function with some firmware versions.
In such a case, the firmware must be upgraded to the latest ver-
sion.
63
63-1
Purpose Adjustment/Setting/Operation data check
Function (Purpose) Used to display the shading correction
result.
Section Scanner
Operation/Procedure
1) Select a target color to display with [R] [G] [B] on the touch
panel.
[RSPF]
Display item Description
ANALOG Analog gain adjustment
GAIN ODD value (odd number)
ANALOG Analog gain adjustment
GAIN EVEN value (even number)
DIGITAL GAIN Digital gain adjustment
ODD value (odd number)
DIGITAL GAIN Digital gain adjustment
EVEN value (even number)
SMP AVE Reference plate
ODD sampling average value
(ODD)
SMP AVE Reference plate
EVEN sampling average value
(EVEN)
TARGET Target value
VALUE
BLACK LEVEL Black output level
ERROR CODE Error code (0, 1 - 14)
Remarks
0: No error
1: Loop number over
2: The target value is
under the speci-
fied value
3: The gain set value is
negative.
4: END is not asserted.
(Gain adjustment)
5: Reserve
6: Underflow
7: Black shading error
8: Other error
9: END is not asserted.
(White shading)
10: END is not asserted.
(Black shading)
MX-3114N SIMULATION 6 – 104
Display item Description
ERROR Error code (0, 1 - 14)
CODE
RSPF BACK
First scan RSPF back
surface white reference
WHITE
level
LEVEL 1ST
RSPF BACK Second scan RSPF back
surface white reference
WHITE
level
LEVEL 2ND
63-2
Purpose Adjustment
Function (Purpose) Used to perform shading.
Section
Operation/Procedure
1) (When RSPF model)
Press [EXECUTE] key.
Used to perform shading.
When the operation is completed, [EXECUTE] key returns to the
normal display.
63-3
Purpose Adjustment
Function (Purpose) Used to perform scanner (CCD) color bal-
ance and gamma auto adjustment.
Section Scanner
Operation/Procedure
1) Place the SIT chart (UKOG-0280FCZZ or UKOG-0280FCZ1)
on the reference position of the left rear frame side of the doc-
ument table.
2) Press [EXECUTE] key.
The scanner (CCD) color balance automatic adjustment is per-
formed.
When the operation is completed, [EXECUTE] key returns to the
normal display.
After completion of the operation, press [RESULT] key, and the
adjustment data are displayed. At that time, the target color of data
display can be selected with [R] [G] [B] key.
Remarks
11: END is not asserted.
(Light quantity
correction)
12: END is not asserted.
13: Register check error
(White booting/Before
gain)
14: Register check error
(Before light quantity
correction)