Sharp MX-2314N Service Manual page 121

1) Enter the SIM 50-10 mode.
EXECUTE
2) Set A4 (11 x 8.5") paper to all the paper feed trays. Select an
adjustment item of the target paper feed tray among items B -
N and enter the adjustment value. Then select item "O" to
select the paper feed tray which is to be used for executing
test printing.
3) Press [EXECUTE] key.
The adjustment pattern is printed.
4) Check the adjustment pattern to confirm that the items below
are in the range of the standard values.
Content
X Lead edge void area
Y Rear edge void area
Z1/Z2 FRONT/REAR void area
X
4.0 1.0mm
If the above condition is not satisfied, or if it is set to a desired
condition, execute the simulation 50-1.
Feed paper from all the paper feed trays to confirm.
EXECUTE
End of print
Standard adjustment value
4.0  1.0mm
2.0 - 5.0mm
2.0  2.0mm
Z1
2.0 2.0mm
Y
2.0 - 5.0mm
Z2
2.0 2.0mm
MX-3114N ADJUSTMENTS AND SETTINGS 5 – 72
5) Enter the SIM 50-1 mode.
10-key
6) Select an adjustment item (DENA, DENB, FRONT/REAR) with
the scroll key, enter the adjustment value, and press [OK] key.
Item/Display
Void area DENA Lead edge void area
adjustment adjustment
DENB Rear edge void area
adjustment
FRONT/ FRONT/REAR void
REAR area adjustment
Sub DENB-MFT Manual feed
scanning correction value
direction
DENB-CS1 Tray 1 correction value
print area
DENB-CS2 Tray 2 correction value
correction
DENB-CS3 Tray 3 correction value
value
DENB-CS4 Tray 4 correction value
DENB-LCC LCC correction value
DENB-ADU ADU correction value
DENB-HV Heavy paper
correction value
When the adjustment value is increased, the void area is
increased. When the adjustment value is decreased, the void
area is decreased.
When the adjustment value is changed by 1, the void area is
changed by 0.1mm.
The adjustment value and the actual void area are related as
follows:
Adjustment value/10 = Actual void area
When the amount of the rear edge void is different between
each paper feed tray, change the adjustment value of item
(DENB-XXX) in SIM50-1 and adjust.
The adjustment item (DENB) have a effect on the paper of all
paper feed tray.
OK
Setting Default
Content
range value
1 - 99 40
1 - 99 30
1 - 99 20
1 - 99 50
1 - 99 50
1 - 99 50
1 - 99 50
1 - 99 50
1 - 99 50
1 - 99 50
1 - 99 50