Parameter Data Set - GE AF-650 GP Programming Manual

3.3 Parameter Data Set

Parameter group related to the fundamental functions of the drive.
3.3.1 F-0# Fundamental 0
3
Parameters to configure frequency command, base speed settings, Torque Boost, and accel/decel time.
F-01 Frequency Setting 1
Option:
[0] No function
[1] * Analog Input 53
[2] Analog Input 54
[7] Frequency input 29
[8] Frequency input 33
[11] Local bus reference
[20] Digital Potentio-Meter
[21] Analog input X30-11
[22] Analog input X30-12
F-02 Operation Method
Option:
[0] * Linked to Hand / Auto
[1] Remote
[2] Local
F-03 Max Output Frequency 1
Range:
132.0 Hz* [1.0 - 1000.0 Hz]
NB!
Max. output frequency cannot exceed 10% of the inverter switching frequency (par. F-26 Motor Noise (Carrier Freq)).
par. F-03 Max Output Frequency 1 cannot be adjusted while the motor is running.
F-04 Base Frequency
Range:
50. Hz* [20 - 1000 Hz]
36
Function:
Select the reference input to be used for the first reference signal. par. F-01 Frequency Setting 1, par.
C-30 Frequency Command 2 and par. C-34 Frequency Command 3 define up to three different reference
signals. The sum of these reference signals defines the actual reference.
(OPCGPIO - General Purpose I/O Option Module)
(OPCGPIO - General Purpose I/O Option Module)
Function:
Select which reference site to activate.
Use local reference when in Hand mode; or remote reference when in Auto mode.
Use remote reference in both Hand mode and Auto mode.
Use local reference in both Hand mode and Auto mode.
NB!
When set to Local [2], the frequency converter will start with this setting again following a 'power down'.
Function:
Provides a final limit on the output frequency for improved safety in applications where you want to avoid
accidental over-speeding. This limit is final in all configurations (independent of the setting in par.
H-40 Configuration Mode).
Function:
Min - Max motor frequency: 20 - 1000 Hz.
AF-650 GP Programming Guide