GE AF-650 GP Programming Manual page 112

SP-53 Fan Monitor
Option:
[0] Disabled
[1] * Warning
[2] Trip
SP-55 Output Filter
Option:
[0] * No Filter
[1] Sine-Wave Filter
SP-56 Capacitance Output Filter
Range:
2.0 uF* [0.1 - 6500.0 uF]
SP-57 Inductance Output Filter
Range:
7.000 mH* [0.001 - 65.000 mH]
SP-59 Actual Number of Inverter Units
Range:
1.* [1 -]
SP-63 Option Supplied by External 24VDC
Option:
[0] No
[1] * Yes
3.9.6 SP-7# Additional ADD/DEC Settings
Parameters to configure the jerk compensations for S-Ramps settings on Accel/Decel Ramps 1 through 4.
SP-71 Accel Time 1 S-ramp Ratio at Accel. Start
Range:
50 %* [1 - 99. %]
Function:
Select which reaction the frequency converter should take in case a fan fault is detected.
Function:
Select if a Sine-Wave output filter connected. This parameter cannot be adjusted while motor is running.
Function:
Set the capacitance of the output filter. The value can be found on the filter label.
NB!
This is required for correct compensation in Flux mode (par. H-41 Motor Control Principle)
Function:
Set the inductance of the output filter. The value can be found on the filter label.
NB!
This is required for correct compensation in Flux mode (par. H-41 Motor Control Principle)
Function:
Set the actual number of power units.
Function:
Select No [0] to use the drive's 24 V DC supply.
Select Yes [1] if an external 24 V DC supply will be used to power the option. I/O will be galvanically isolated
from the drive when operated from an external supply.
Function:
Enter the proportion of the total accel time (par. F-07 Accel Time 1) in which the acceleration torque
increases. The larger the percentage value, the greater the jerk compensation achieved, and thus the
lower the torque jerks occurring in the application.
AF-650 GP Programming Guide
3
111