GE AF-650 GP Programming Manual page 53

Preset ramp bit
Ramp 1
Ramp 2
Ramp 3
Ramp 4
[36] Mains failure inverse
[41] Latched Precise Stop inverse
3
[55] DigiPot Increase
[56] DigiPot Decrease
[57] DigiPot Clear
[60] Counter A
[61] Counter A
[62] Reset Counter A
[63] Counter B
[64] Counter B
[65] Reset Counter B
[70] Mech. Brake Feedback
[71] Mech. Brake Feedback inv.
[80] PTC Card 1
E-00 Digital I/O Mode
Option:
[0] * PNP
[1] NPN
NB!
Once this parameter has been changed, it must be activated by performing a power cycle.
This parameter cannot be adjusted while the motor is running.
E-01 Terminal 18 Digital Input
Option:
[0] No operation
[1] Reset
[2] Coast inverse
[3] Coast and reset inv
[4] Quick stop inverse
[5] DC-brake inverse
[6] Stop inverse
[8] * Start
[9] Latched start
[10] Reversing
[11] Start reversing
[12] Enable start forward
[13] Enable start reverse
[14] Jog
52
Activates par. SP-10 Line failure. Mains failure inverse is active in the Logic .0. situation.
Sends a latched stop signal when the precise stop function is activated in par. H-83 Precise Stop Func-
tion. The Latched Precise stop inverse function is available for terminals 18 or 19.
INCREASE signal to the Digital Potentiometer function described in parameter group F-9#
DECREASE signal to the Digital Potentiometer function described in parameter group F-9#
Clears the Digital Potentiometer reference described in parameter group F-9#
(Terminal 29 or 33 only) Input for increment counting in the LC counter.
(Terminal 29 or 33 only) Input for decrement counting in the LC counter.
Input for reset of counter A.
(Terminal 29 or 33 only) Input for increment counting in the LC counter.
(Terminal 29 or 33 only) Input for decrement counting in the LC counter.
Input for reset of counter B.
Brake feedback for hoisting applications
Inverted brake feedback for hoisting applications
All Digital Inputs can be set to PTC Card 1 [80]. However, only one Digital Input must be set to this choice.
Function:
Digital inputs and programmed digital outputs are pre-programmable for operation either in PNP or NPN
systems.
Action on positive directional pulses (↕). PNP systems are pulled down to GND.
Action on negative directional pulses (↕). NPN systems are pulled up to + 24 V, internally in the frequency
converter.
Function:
Select the function from the available digital input range.
AF-650 GP Programming Guide
1 0
0 0
0 1
1 0
1 1