Dr-## Data Read-Outs - GE AF-650 GP Programming Manual

3.17 DR-## Data Read-outs

Parameter group related to data readouts in the drive for references, voltages, control, alarms, warnings, and status words.
3.17.1 DR-0# General Status
Parameters to view the calculated references, the active control word, and status word.
DR-00 Control Word
Range:
0* [0 - FFFFF]
DR-01 Reference [Unit]
Range:
0.000* [-999999.000 - 999999.000]
DR-02 Reference [%]
Range:
0.0 %* [-200.0 - 200.0 %]
DR-03 Status Word
Range:
0* [0 - FFFFF]
DR-05 Main Actual Value [%]
Range:
0.00 %* [-100.00 - 100.00 %]
DR-09 Custom Readout
Range:
0.00 Unit* [x.ss - x.xx Unit]
3.17.2 DR-1# Motor Status
Parameters to view the motor status values.
DR-10 Power [kW]
Range:
0.00 kW* [0.00 - 10000.00 kW]
DR-11 Power [hp]
Range:
0.00 hp* [0.00 - 10000.00 hp]
Function:
View the Control word sent from the frequency converter via the serial communication port in hex code.
Function:
View the present reference value applied on impulse or analog basis in the unit resulting from the con-
figuration selected in par. H-40 Configuration Mode (Hz, Nm or RPM).
Function:
View the total reference. The total reference is the sum of digital, analog, preset, bus, and freeze refer-
ences, plus catch-up and slow-down.
Function:
View the Status word sent from the frequency converter via the serial communication port in hex code.
Function:
View the two-byte word sent with the Status word to the bus Master reporting the Main Actual Value.
Function:
View the value of custom readout from par. K-30 Unit for Custom Readout to par. K-32 Max Value of
Custom Readout
Function:
View the motor power in kW. The value shown is calculated on the basis of the actual motor voltage and
motor current. The value is filtered, and therefore approx. 30 ms may pass from when an input value
changes to when the data read-out values change.
Function:
View the motor power in HP. The value shown is calculated on the basis of the actual motor voltage and
motor current. The value is filtered, and therefore approximately 30 ms may pass from when an input
value changes to when the data read-out values change.
AF-650 GP Programming Guide
3
141