Start-Up And Operation - KEB COMBIVERT F6 Series Instructions For Use Manual

bASIc SAFeTy INSTrUcTIONS

1.5 Start-up and operation

The drive converter must not be started until it is determined that the installation com-
plies with the machine directive; Account is to be taken of
WArNING
cAUTION
•
•
•
NOTICE
Software protection and programming !
Hazards caused by unintentional behavior of the drive!
► Check especially during initial start-up or replacement of the drive
converter if parameterization is compatible to application.
► Securing a unit solely with software-supported functions is not suf-
ficient. It is imperative to install external protective measures (e.g.
limit switch) that are independent of the drive converter.
► Secure motors against automatic restart.
High temperatures at heat sink and coolant!
burning of the skin!
► Cover hot surfaces safe-to-touch.
► If necessary, attach warning signs on the system.
► Before touching, check the surface and coolant lines.
► Before working let the unit cool down.
During operation, all covers and doors shall be kept closed.
Use only approved accessories for this device.
Never touch terminals, busbars or cable ends.
If a drive converter with electrolytic capacitors in a DC link
(see technical data) has not been in operation for more than
one year, observe the following instructions.
www.keb.de/fileadmin/media/Manuals/knowledge/04_techinfo/00_gene-
ral/ti_format_capacitors_0400_0001_gbr.pdf
continuous operation (S1) with load > 60 % or from a rated motor
power of 55 kW !
Premature ageing of the electrolytic capacitors !
► Mains choke with U
EN 60204-1.
= 4% absolutely necessary.
k
19