The "Drive Mode; Start / Stop Drive; Changing The Direction Of Rotation; Speed Setting - KEB COMBIVERT F5 series Installation Manual & Operation Manual

Drive Mode

4.7 The "Drive Mode"

4.7.1 Start / Stop
Drive
4.7.2 Changing
the Direction
of Rotation
4.7.3 Speed set-
ting
4.7.4 Leaving the
"Drive Mode"
The Drive Mode is a operating mode of KEB COMBIVERT that permits the
manual starting of the through the keypad display unit. After applying a signal
to the control release terminal 16, the set value (speed ref.) and rotation
setting are effected exclusively over the keypad. In order to activate the
Drive Mode the corresponding password (500) must be entered in CP .0.
The display switches over as follows.
Direction of rotation
F= forward, r= reverse
Modulation blocked,
Drive in standby mode
START
Drive accelerates up
to the adjusted set
value (speed ref.)
ENTER
F/R
FUNC.
SPEED
To exit the Drive Mode the inverter must be in status "stop" (Display noP or
LS). Press the FUNC and ENTER keys simultaneously for about 3 seconds
to leave the Drive Mode. The CP-parameters appear in the display.
for 3 seconds
Status
noP= "control release" deactivated
LS= neutral position
Drive decreases to 0 Hz and
switches the modulation off
STOP
Drive operates with adjusted set
value (speed ref.)
Drive changes direction of rotation
STOP
START
+
FUNC.
SPEED
The display changes when the
FUNC/SPEED key is pressed. The
set frequency is displayed.
Set frequency can be changed with
the UP/DOWN keys while holding
the FUNC/SPEED key
ENTER
F/R
37