Menu 11.3 - Remote Node Network Layer Options; Figure; Table 7-2 Remote Node Network Layer Options - ZyXEL Communications Prestige 642R Series User Manual

VPI/VCI (LLC-mux or PPP/PPPoE Encap):
VPI #= 0
VCI #= 35
IP Options:
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
Single User Account= Yes
Metric= 2
Private= No
RIP Direction= None
Version= RIP-1
Multicast= None
IP Policies=

Figure 7-2

The following table describes the bridging-dependent parameters in the Remote Node Profile and Network
Layers menus.
FIELD
Bridge (Menu 11.1)
Edit IP/IPX/Bridge
(Menu 11.1)
Dial-On-Broadcast
(Menu 11.3)
Ethernet Addr Timeout
(min) (Menu 11.3)
Once you have completed filling in the Remote Node Network Layer Options menu, press [Enter] to
return to Menu 11.1. Then press [Enter] at the message [Press ENTER to Confirm...] to save your
configuration, or press [Esc] to cancel.
Bridging Setup

Menu 11.3 - Remote Node Network Layer Options

Enter here to CONFIRM or ESC to CANCEL:
Menu 11.3 - Remote Node Network Layer Options
Table 7-2 Remote Node Network Layer Options
Make sure this field is set to Yes.
Press [space bar] to change it to Yes and press [Enter] to go to the Remote
Node Network Layer Options menu.
This field is necessary for your Prestige on the caller side LAN. When set to
Yes, any broadcasts coming from the LAN will trigger your Prestige to make
a call to this remote node. If it is set to No, your Prestige will not make the
outgoing call.
In this field, enter the time (number of minutes) that you wish your Prestige to
retain the Ethernet Address information in its internal tables while the line is
down. If this information is retained, your Prestige will not have to recompile
the tables when the line is brought back up.
Prestige 642R Series ADSL Router
IPX Options:
Rem LAN Net #= N/AS
My WAN Net #= N/A
Hop Count= N/A
Tick Count= N/A
W/D Spoofing(min)= N/A
SAP/RIP Timeout(min)= N/A
Dial-On-Query= N/A
Bridge Options:
Dial-On-Broadcast= No
Ethernet Addr Timeout(min)= 0
DESCRIPTION
7-3