Applying An Ip Policy; Ethernet Ip Policies - ZyXEL Communications Prestige 642R Series User Manual

Precedence
Source:
addr start= /
end=
port start= /
end=
Destination:
addr start= /
end=
port start= /
end=
Action=
Gateway addr
Log
Type of Service
Precedence

11.2 Applying an IP Policy

This section shows you where to apply the IP Policies after you design them.

11.2.1 Ethernet IP Policies

From Menu 3 - Ethernet Setup, enter 2 to go to Menu 3.2 -General Ethernet Setup.
You can choose up to four IP Policy sets (from twelve) by entering their numbers separated by commas,
e.g., 2, 4, 7, 9.
IP Policy Routing
Precedence value of the incoming packet. Values range from [0] to [7] or [Don't
Care].
Source IP address range from start to end.
Source port number range from start to end; applicable only for TCP/UDP.
Destination IP address range from start to end.
Destination port number range from start to end; applicable only for TCP/UDP.
Specifies whether action should be taken on criteria [Matched] or [Not
Matched].
Defines the outgoing gateway address. The gateway must be on the same
subnet as the Prestige if it's on the LAN, otherwise, the gateway must be the IP
address of a remote node. The default gateway is specified as 0.0.0.0.
Press [SPACE BAR] to select Yes to make an entry in the system log when a
policy is executed.
Set the new TOS value of the outgoing packet. Choose from Prioritize incoming
network traffic by choosing from [No Change] / [Normal] / [Min Delay] / [Max
Thruput] / [Max Reliability].
Set the new precedence value of the outgoing packet. Values range from [0] to
[7] or [No Change].
Prestige 642R Series ADSL Router
11-5