Chapter 2 Hardware Installation & Initial Setup; Front Panel Leds Of The P642R; Rear Panel And Connections Of The Prestige 642R; Figure 2-1 Prestige 642R Series Front Panel - ZyXEL Communications Prestige 642R Series User Manual

Hardware Installation & Initial Setup
This chapter describes the physical features of the Prestige and how to make the cable
2.1

Front Panel LEDs of the P642R

The LED indicators on the front panel indicate the operational status of the Prestige 642. The table below
the diagram describes the LED functions:
PWR The PWR (power) LED is on when power is applied to the Prestige.
SYS A steady 'on' SYS (system) LED indicates the Prestige is on and functioning
properly while an 'off' SYS LED indicates the system is not ready or has a
malfunction. The system is rebooting when the SYS LED is blinking.
LAN 10M A steady light indicates a 10Mb Ethernet connection. The LED will blink when data
is being sent/received.
LAN 100M A steady light indicates a 100Mb Ethernet connection. The LED will blink when data
is being sent/received.
ADSL The ADSL LED is on when the Prestige is connected successfully to a DSLAM. The
LED blinks when data is being sent/received. The LED is off when the link is down.
2.2

Rear Panel and Connections of the Prestige 642R

The following figure shows the rear panel connectors of your Prestige:
Hardware Installation & Setup

Figure 2-1

Prestige 642R Series Front Panel.
Table 2-1 Front Panel LED Description
Prestige 642R Series ADSL Router
Chapter 2
connections
.
2-1