Ip Routing Policy; Policy Setup - ZyXEL Communications Prestige 642R Series User Manual

Prestige 642R Series ADSL Router
MT
MR
MC
Enter a number from 1 to 6 to display Menu 25.1.1 – IP Routing Policy (see the next figure). This menu
allows you to configure a policy rule.
Policy Set Name= test
Active= Yes
Criteria:
IP Protocol
Type of Service= Normal
Precedence
Source:
Destination:
Action= Matched
Gateway addr
Type of Service= Max Thruput
Precedence
Press Space Bar to Toggle.
Field
Policy Set Name
Active
Criteria
IP Protocol
Type of Service
Packet Length
Len Comp
11-4
Maximum Throughput
Maximum Reliability
Minimum Cost
Menu 25.1.1 - IP Routing Policy
= 6
= 0
addr start= 1.1.1.1
port start= 20
addr start= 2.2.2.2
port start= 20
= 192.168.1.1
= 0
Press ENTER to Confirm or ESC to Cancel:
Figure 11-3
Table 11-2
This is the name of the policy set assigned in Menu 25 - IP Routing

Policy Setup.

[SPACE BAR]
Press
IP layer 4 protocol, e.g., UDP, TCP, ICMP, etc.
Prioritize incoming network traffic by choosing from [Don't Care] / [Normal] /
[Min Delay] / [Max Thruput] / [Max Reliability].
Enter the length of incoming packets (in bytes). The operators in the [Len
Comp] (next) apply to packets of this length.
Press to choose from [Equal] / [Not Equal] / [Less] / [Greater] / [Less or Equal] /
Greater or Equal].
Packet length= 40
Len Comp=
end= 1.1.1.1
end= 20
end= 2.2.2.2
end= 20
Log= No

IP Routing Policy

IP Routing Policy
Description
to select Yes to activate the policy.
IP Policy Routing