ZyXEL Communications Prestige 642R Series User Manual page 65

Prestige 642R Series ADSL Router
Multiplexing
Incoming:
Rem Login
Rem Password
Outgoing:
My Login
My Password
Route
Bridge
Edit PPP Options
4-4
Press [space bar] to select the multiplexing method.
Enter the login name that this remote node will use
when it calls your Prestige. The login name in this field
combined with the Rem Password will be used to
authenticate this node.
Enter the password used when this remote node calls
your Prestige.
Enter the login name assigned by your ISP when the
Prestige calls this remote node.
Enter the password assigned by your ISP when the
Prestige calls this remote node.
This field sets the authentication protocol used for
Authen
outgoing calls. Options for this field are:
CHAP/PAP – Your Prestige will accept either
CHAP or PAP when requested by this remote
node.
CHAP – accept CHAP (Challenge Handshake
Authentication Protocol) only.
PAP – accept PAP (Password Authentication
Protocol) only.
This field determines the protocol that your Prestige will
route.
Bridging is used for protocols that the Prestige does not
route, e.g., SNA, or not turned on in the previous Route
field. When bridging is enabled, your Prestige will
forward any packet that it does not route to this remote
node; otherwise, the packets are discarded. Press the
[space bar] to toggle between the options.
To edit the PPP options for this remote node, move the
cursor to this field. Use [space bar] to select Yes and
press [Enter]. This will bring you to Menu 11.2
Remote Node PPP Options. For more information on
configuring PPP options, see the section Editing PPP
VC-based
LLC-based
CHAP/PAP
CHAP
PAP
IP / IPX /
IP+IPX /
None
Yes or No
Press [space
bar] to toggle
Yes then
–
press [Enter]
Remote Node Configuration